The filter barrel of the small electroplating filter adopts a one-piece design and has no welding points. The small electric filter has the characteristics of corrosion resistance and high temperature resistance, and is widely used in industrial production such as electroplating, surface treatment, and metal finishing. So what should we pay attention to in the process of using the electroplating filter? Today, I will introduce to you the precautions for the operation of the electroplating filter.
1. Before using the small electroplating filter, it is necessary to check whether the entrance and exit are in good order, and then fix the entrance and exit pipes in the tank, and fasten the entrance and exit to prevent loosening.
2. Open the medicine valve and the exhaust valve, and then pour water from the dosing valve through the dosing tank into the inlet pipe and the pump, so that the inlet pipe is completely filled with liquid.
3. Before starting the electroplating filter motor, check whether the motor wiring voltage and voltage are correct to avoid mistakes.
4. First lock the dosing valve and then open the exhaust valve so that the gas is discharged into the dosing tank through the conduit, before starting the motor of the electroplating filter.
5. After completing the above inspections, the starter motor starts to work, and it is necessary to check whether the pumping direction of the electroplating filter is correct.
Of course, it is not enough to pay attention to how to use it, and it is also necessary to maintain the small electroplating filter.
1. Many users think that the greater the spring compression of the small electroplating filter, the better the sealing effect. In fact, this is not the case. Excessively compressing the spring will cause it to lose its elasticity, and the seal will fail; if the spring is too compressed, it will cause the friction pair to wear.
2. Many users think that the tighter the static sealing ring, the better. In fact, it is not. If the English static sealing ring is too tight, it will affect the sealing effect and affect the sealing effect.
3. Many users think that the impeller lock nut is not tightly locked, but this is not the case. The leak between the shafts and the tight lock nut will only lead to premature failure of the inter-shaft pad. In addition, in the leakage of the electroplating filter, the leakage between the shaft and the sleeve is generally common.
Post time: Mar-04-2023